Citroen OBD-2 diagnostic pinout for Citroen Xantia, Saxo, Picasso, Nemo, Jumpy, C5, Jumper, C8, Evasion, DS4, DS3, C-Crosser, C8, C6, C5, C4, C3, C2, C1, Berlingo Van.

Audi OBD-II diagnostic interface pinout for Audi Quattro, Q7, Q5, Coupe, Cabrio, B5 Avant, B5, A3, A4, B4, Allroad, A6, A8, A6 Avant, A6 Allroad, A6, A5, A4/S4, A4 Kombi, A4 Cabrio.The pinouts for the 16 pin J1962 OBD-2 car diagnostic connector are: The type A connector (shown) is used for vehicles that use 12V supply voltage, whereas type B is used for 24V vehicles and it is required to mark the front of the D-shaped area in blue color. You can, however, mate a type B male plug in a type A female socket. But type B has the groove interrupted in the middle, so you can't plug a type A male connector into a type B socket. Both are female, 16-pin (2x8), D-shaped connectors, and both have a groove between the two rows of pins. The SAE J1962 specification provides for two standardized hardware interfaces, called type A and type B. Two factors will show if your vehicle is definitely OBD II equipped:ġ) There will be an OBD II connector as shownĢ) There will be a note on a sticker or nameplate under the hood: 'OBD II compliant'. The connector must be located within three feet of the driver and must not require any tools to be revealed. In general, this means all 1996 model year cars and light trucks are compliant, even if built in late 1995. This is the 16 pin J1962 OBD-2 car diagnostic connectorĪll cars and light trucks built and sold in the United States after Januwere required to be OBD II equipped.

Corsa d obd port location